SRS Airbag Programming

• Airbag light is on?
• Vehicle was in an accident?
• Airbag(s) have deployed ?
• Diagnostic tool shows "crash data stored" ?
• Dealer says you need a new module?

Even after a minor accident srs airbag module will register crash data codes into its memory. Which will make the airbag light illuminate on your dashboard.

(Airbag SRS control modules are also known as"sdm", "sensor", "computer", "derm" and "brain.")

We reset crash data codes stored in your airbag srs module to original OEM state.

Virtually all 1996-2017 airbag control modules can be reset and reprogrammed, except if flood, fire or hardware damage.

note: if vehicle had one or more AirBags deployed and/or Seatbelt(s) locked up, those must be repaired first, before Installing Repaired AirBag Module into the vehicle!

It is always best to send your original module to us for reset to avoid additional trip to the dealer for coding. Most of the late model cars will have partial VIN stored in the airbag control module.

Failure to follow instructions below may result in the accidental deployment of "air bag”, "seat belt”, which increases the risk of serious personal injury or death

Never probe the electrical connectors on air bag or seat belt.
Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.

SRS Airbag Module Removal & Installation Procedure:

in order to correctly and safely Remove and Install Your SRS Airbag module follow these steps

Removing SRS AirBag Computer Module: 

1. Disconnect battery negative than positive terminal.
2. Remove SRS airbag module.

Installing SRS AirBag Computer Module:

1. Disconnect battery negative first than positive terminal.
2. Install and connect SRS airbag module. (make sure to install all grounding screws!)
3. Reconnect battery. Turn switch to "accessory".
4. Wait few seconds until the SRS light stops flashing.
5. Turn off the key. (SRS Airbag Module is now correctly installed)